![]() |
|
RB Robotics |
|
|
Approximate Build Time: Parts List
1000-5014 Led Pack 2000-35001 1 Cable, Molded, 20 to 24 Conductor from the cable pack Assembly Steps:Refer to figure 1. ( ) Install five 330 ohm (Orange-Orange-Brown) resistors ( ) Install 1N4001 Diode Refer to figure 2 ( ) Install Orange LED in center of board with the flat side of the LED facing the bottom of the board Refer to figure 3 ( ) Install 4 Clear LEDs with the flat side of the LED facing the bottom of the board Refer to figure 4 ( ) Install 4 Yellow LEDs with the flat side facing the bottom of the board. Refer to figure 5 ( ) Install four FCC92 Transistors Refer to figure 6 ( ) Install four Green LEDs with the flat side of the LED facing the bottom of the board Refer to figure 7 ( ) Install eight Red LEDs with the flat side of the LED facing the bottom of the board Figure 7 Refer to figure 8 ( ) Install 24-pin socket with the notch to the left ( ) Install 16-pin socket the the notch to the left Refer to figure 9 ( ) Install jumper wire This concludes your LED board subassembly assembly
|
|
Copyright © 2005 RB Robotics | |